Pages

Monday, December 2, 2013

RESETTER PRINTER CANON PIXMA XNU i255 PART 2

CANON PIXMA XNU i255 PART 2
After the head cleaning your printer can not nge-print? The power button and the button stays on continuously aka Blinking error. Do not blame anyone! Thats because the protection counter that is to save your printer, meaning the protection counter tells you that the ink waste in the holding tank is full.

If only these counters Protection does not tell you it will continue to discharge the ink tank is filled when doing the head cleaning and flood management to your printer and your printer probably will be completely destroyed. So due to this printer is not working and shelter must be in clean tank / emptied first. After that you must reset the protection counter with the help of special software.
Too bad the software to reset the counter of his protection was not provided in the sales package printer.
Software to reset the protection counter you can get.

Here is how to use the Software Resetter Canon i350, Pixus350i, i355, i250, i255.

Before using the Software Resetter Canon i350, Pixus350i, i355, i250, i255, make sure the printer drivers that will advance the reset has been installed, and make sure that the USB printer is installed properly.


One. How to make a normal printer (reset temporary)

• Remove the power cable.

• Press the power button on the printer, replace the power cable (with power) without releasing the pressure on the power button on the printer.

• Press the reset button (below the power button) as much as two times (do not release the power button first).

• Release the pressure on the power of the printer. Wait until the green light and not blinking.

• The printer has NORMAL again (for a while, and will come back blink when the power cable / power off / removed.)

2. To run the program. (Reset permanent)

• Ensure Software Resetter Canon i350, Pixus350i, i355, i250, i255 you already have and are on your computer, if not you can find HERE.

• Put as many as three sheets of paper for the TEST PRINT

• Open the Folder Software Resetter Canon i350, Pixus350i, i355, i250, i255 are there on your computer and open the files General Tool.

• Select USB USB PORT on the menu on the right above. (Point 1)

• Check / click on the column EEPRsaya CLEAR. (Point 2)

• On the SET DESTINATION Menu, click and select the i350 or i355 or i250 or Pixus350i or i255 according to the type of printer that will be reset. (Point 3)

• In the menu select PRINT TEST TEST PATTERN 1. (Point4)

• In the menu select PRINT TEST TEST PATTERN 2. (Point5)

• Once completed print test results, turn off the printer and unplug the power cable to the storage reset the printer EEPRsaya data to the printer

• Replace the power cable and turn on the printer. Wait until the printer finished initialing and the printer does not blink again
ReadMore...

Sunday, December 1, 2013

HP Laserjet 4000 and 4050 series service mode

1 Hold down [Select] and [Cancel Job] while turning on the printer until all of the lights on the Control Panel are lit. (If the Control Panel reads INITIALIZING, the keys were released too soon.)
2 Press the right side of the [Menu] key, then press [Select]. The message SERVICE MODE is displayed.
3. Press [Menus] once to display SERVICE MENU.
4. Once it says SERVICE MENU press ITEM to scroll through service mode items.
5. To exit the Service Mode press [Go].
ReadMore...